Overrunning Clutches & Backstops

ASNU

Stieber Clutch Asnu Type

Type ASNU is a roller type freewheel non-bearing supported. Bearings are required to support axial and radial loads. Lubrication and sealing must also be provided by the installation. Nominal outer diameter is the same as a series 63.. ball bearing.

A typical arrangement is to install this type alongside a bearing within the same location tolerances, as shown on the following page. The inner race is keyed to the shaft. The outer race has positive n6 tolerance, to give a press fit in a H7* housing. Additional side notches in the outer race provide for positive torque transmission.

If the housing is to K6* tolerance, use of the notches is not necessary, but the housing must be strong enough to not expand after assembly. This design can accept an axial misalignment of inner and outer race of ± S/2*.

*These data refer to the indications in the product data sheet attached below (on page 2).

  • Altra Industrial Motion - Australia (Sydney)
  • Sydney New South Wales
  • Unit 1, 11 Penny Place
  • Arndell Park, NSW. 2148
  • Phone: 1300 ALTRAMOTION
  • Altra Industrial Motion - Australia (Melbourne)
  • Melbourne Victoria
  • Suite 36, Level 2/222 Lonsdale Street
  • Melbourne, VIC 3000
  • Phone: 1300 ALTRAMOTION
  • Altra Industrial Motion - Australia (Mackay Queensland)
  • Mackay Queensland
  • 14/20-34 Caterpillar Drive
  • Paget, QLD 4740
  • Phone: 1300 ALTRAMOTION
  • Altra Industrial Motion - Australia (Perth)
  • Perth Western Australia
  • 271 Great Eastern Highway
  • Belmont, WA 6104
  • Phone: 1300 ALTRAMOTION