Overrunning Clutches & Backstops

DC

Stieber Clutch DC Type

Type DC is a sprag type freewheel cage without inner or outer races. It must be installed in a design providing races, bearing support for axial and radial loads, lubrication and sealing. The DC type version-N accepts all types of lubricants currently used in the power transmission equipment.

The sprag space tolerance must not be exceeded. Inner and outer races must both have a minimum plain width “e*”, without any recess, to ensure the freewheel functions correctly as shown on following pages.

Alternatively, races can be made in case hardened steel shafts, or housings, to the specification below. Surface hardness of the finished part should be HRC 60 to 62, for a depth of 0,6 mm minimum.

Core hardness to be HRC35 to 45. Surface roughness not to exceed 22CLA. Maximum taper between races: 0,007 mm for 25 mm width.

*These data refer to the indications in the product data sheet attached below (on page 2).

  • Altra Industrial Motion - Australia (Sydney)
  • Sydney New South Wales
  • Unit 1, 11 Penny Place
  • Arndell Park, NSW. 2148
  • Phone: 1300 ALTRAMOTION
  • Altra Industrial Motion - Australia (Melbourne)
  • Melbourne Victoria
  • Suite 36, Level 2/222 Lonsdale Street
  • Melbourne, VIC 3000
  • Phone: 1300 ALTRAMOTION
  • Altra Industrial Motion - Australia (Mackay Queensland)
  • Mackay Queensland
  • 14/20-34 Caterpillar Drive
  • Paget, QLD 4740
  • Phone: 1300 ALTRAMOTION
  • Altra Industrial Motion - Australia (Perth)
  • Perth Western Australia
  • 271 Great Eastern Highway
  • Belmont, WA 6104
  • Phone: 1300 ALTRAMOTION